News
07/08/2024
Deliveries of updated bulldozer engines have started at TMP

Since June, the Tutaev Motor Plant, KAMAZ subsidiary in the Yaroslavl region, has been supplying diesel engines 8523 with cast-iron cylinder heads to the Promtractor plant in Cheboksary for mass production of a new model of tracked bulldozer.

The partner of TMP PTC, Cheboksary Promtractor plant, has launched a new model of CHETRA T30.03 tracked bulldozer into mass production. According to the manufacturer, the vehicle equipped with a new diesel engine with a cast-iron cylinder head has successfully passed tests at the site of JSC Kuzbassrazrezugol Management Company. In terms of the volume of displaced rock and fuel consumption, T30 bulldozer proved to be more efficient than similar foreign vehicle.

CHETRA T30 is the next generation vehicle designed to replace the previous models of CHETRA T25 bulldozers. The weight of the vehicle is 52 tons, and the engine capacity is 507 HP. The vehicle is equipped with TMZ 8523 diesel engine with a cast–iron cylinder head, an electronic control system, a turbocharger with improved characteristics, a water pump with a gear drive that does not require maintenance.

NAPI (National Industrial Information Agency)


Назад
Other news from section:
06.09.2024
KAMAZ Press and Frame Plant continues to robotize production
Robotization of production continues at the KAMAZ Press and Frame Plant. Following the chassis workshop, where four robotic cells are now functioning, mechanical assistants with software control appeared in the frame assembly workshop. A cell of two robotic complexes was placed at the welding site of the crossbar assemblies. In a few months, they shall master the manufacture of the frame part, which is used for many models of K3 generation...
04.09.2024
The manual laser welding system is being tested at NEFAZ
A manual laser welding system is being tested at NEFAZ, KAMAZ subsidiary in Bashkortostan. With such welding, the time for seam is significantly reduced due to the high concentration of energy in the laser beam, in many cases preliminary cutting of the edges is not required, there is no need to wait for the seam to cool down between passes. The welding process with a laser device is non-contact. Tests of the new equipment will last for a...